2. Apply cement to the gap. Allow the cement to flow in by capillary action (sucked into the gap).
3. Squeeze the 2 pieces until excess plastic flows out.
4. Wait about a day for the plastic to harden before sanding. You should be able to reduce the visibility of the seam line.
Another good tutorial, Uncle Erik! =D
ReplyDeleteGreat tutorial, i was wondering if i did not manage to squeeze out the excess plastic, what should i do?
ReplyDelete@menagunplacorner thks for the thumbs up.
ReplyDelete@CHong Hiu Fung, probably you didn't use enough cement. Worst case is to use putty to fill any remaining gap or hole.